Paper Search Console

Home Search Page About Contact

Journal Title

Title of Journal: Metallurgist

Search In Journal Title:

Abbravation: Metallurgist

Search In Journal Abbravation:

Publisher

Springer US

Search In Publisher:

DOI

10.1016/0022-4731(78)90710-0

Search In DOI:

ISSN

1573-8892

Search In ISSN:
Search In Title Of Papers:

Effect of the composition of the raw materials on

Authors: A A Panychev A P Nikonova
Publish Date: 2010/03/27
Volume: 53, Issue: 11-12, Pages: 713-717
PDF Link

Abstract

A study is made of the effect of certain components of the charge used in sintering on the impact strength of the sinter in drum tests Approximate equations are presented and sintering parameters are optimized good sinter strength is obtained when the content of trivalent iron in the sinter is 64 the total content of calcium oxide and magnesium oxide basic oxides is 143 the total content of silica and alumina acidic oxides is 107 the basicity of the charge is 134 and the content of titanium dioxide in the charge is 0045

Keywords:

References

.
Search In Abstract Of Papers:
Other Papers In This Journal:
  1. Study of the movement of charge materials in the shaft of a blast furnace
  2. Shears for cutting rolled shapes and thick-walled tubes
  3. Reducing the incidence of anode effects at the Krasnoyarsk aluminum plant
  4. Synthesis of Al–Ni Intermetallic Compounds by Mechanical Alloying
  5. Phase Formation during Nonequilibrium Crystallization of Al–Mg–Si System Alloys
  6. Microstructural analysis of the surface of step-shaped parts
  7. Casting of steel into ingot molds as a “submerged” jet
  8. Development of economically alloyed structural steel of strength classes 345 and 390
  9. Acidic-Ultrasonic Refining of Silicon by Carbothermic Technology
  10. Heat-Insulating Paints – An Effective Method of Saving Energy Resources
  11. Effect of Single-Crystal Billet Macro- and Microstructure on Intermetallic Alloy Static and Dynamic Strength
  12. Mineral species of components of silicon-bearing iron ore – an indicator of pellet-strengthening
  13. Developing and Studying Methods and Equipment for Rolling Collector Profiles Made of Alloy BrKd1
  14. Efficiency of using different types of charging apparatuses on blast furnaces
  15. Dynamics of the Change in the Thermal Parameters of the Heat Exchanger and Bio-deposits in the Water-Circulation System of a Metallurgical Unit
  16. Crystallographic aspects of iron-graphite composite homogenization
Search Result: