Experimental study on surface integrity of Ti6Al

Authors: Xiaoyong Yang Chengzu Ren Yan Wang Guang Chen

Publish Date: 2012/06/05

Volume: 18, Issue: 3, Pages: 206-212

PDF Link

Abstract

Aiming at the surface integrity of titanium alloy Ti6Al4V in high speed side milling a series of side milling tests were carried out with uncoated carbide milling cutter at various milling speeds Surface roughness residual stress subsurface microstructure and microhardness variations were investigated The surface roughness measurement results present that the milling speed from 80 to 120 m/min fails to produce better and more stable roughness values compared with the result obtained from 320 to 380 m/min The residual stresses in the feed direction and axial depth of cut direction are in similar trends for the two milling speed levels mentioned above Moreover the residual stress produced at 320 to 380 m/min is lower and more stable than that at 80 to 120 m/min The microstructure analysis shows that the volume of β phase in the near surface becomes smaller and the deformation of β phase in the near surface becomes obvious with the increase of the milling speed Subsurface microhardness variation was observed down to 200 μm below the machined surface at 80 to 120 m/min and down to 160 μm at 320 to 380 m/min It is concluded that better surface integrity and higher material removal rate can be obtained at 320 to 380 m/min than at 80 to 120 m/min

Keywords: