Paper Search Console

Home Search Page About Contact

Journal Title

Title of Journal: Int J Mater Form

Search In Journal Title:

Abbravation: International Journal of Material Forming

Search In Journal Abbravation:

Publisher

Springer-Verlag

Search In Publisher:

ISSN

1960-6214

Search In ISSN:
Search In Title Of Papers:

Peak load in rapid compression tests experiments

Authors: Véronique Favier Helen Atkinson
Publish Date: 2009/12/15
Volume: 2, Issue: 1, Pages: 773-
PDF Link

Abstract

Rapid compression tests are useful to characterize the semisolid behaviour in thixoforming conditions The loaddisplacement curves typically display a peak load The origin the maximum value and the height of this peak are discussed comparing calculated results obtained using a micromacro model and experimental data obtained in earlier work As suggested by experiments the calculated peak load originates from a 3D continuous solid skeleton which breaks down under load For the same initial semisolid structure the model predicts that decreasing the ram speed decreases the maximum of the peak because of a strain rate effect In addition the peak load is found to be quite sensitive to initial internal structure namely the volume fraction of entrapped liquid which may change for various soaking times Finally the time for the solid skeleton breakdown is found to be in good agreement with experimental results

Keywords:

References

.
Search In Abstract Of Papers:
Other Papers In This Journal:
  1. A hybrid method for detecting the onset of local necking by monitoring the bulge forming load
  2. Research on Friction during Hot Deformation of Al-Alloys at High Strain Rate
  3. Tubular scaffold for vascular tissue engineering application
  4. Effect of austenitic crystal orientation in a multiphase steel analyzed by a discrete dislocation-transformation model
  5. Multi Stage Strategies for Single Point Incremental Forming of a Cup
  6. Performance variability of aluminium hybrid LAP-joints obtained by means of adhesives and ultrasonic welding
  7. Regularization and perturbation technique to solve plasticity problems
  8. Optimizing the deepdrawing of multilayered woven fabric composites
  9. Towards robust simulations in sheet metal forming
  10. On the adaptive use of the Taylor assumption in computational homogenization of thin metal sheets
  11. Thermal stability of laser treated die material for semi-solid metal forming
  12. Droplet dynamics in sub-critical eccentric flows
  13. Crystal plasticity prediction of Lankford coefficients using the MULTISITE model: influence of the critical resolved shear stresses
  14. Influence of sintering parameters on dynamic mechanical properties of selective laser sintered parts
  15. Hypoelastic, hyperelastic, discrete and semi-discrete approaches for textile composite reinforcement forming
  16. Investigating the effects of cross wedge rolling preforming operation and die forging with flash brakes on forging titanium hip implants
  17. Variation of components by automated driving
  18. Comparison of two models for anisotropic hardening evolution in metals during complex loading
  19. Formability analysis of thin press hardening steel sheets under isothermal and non-isothermal conditions
  20. An investigation into thickness distribution in single point incremental forming using sequential limit analysis
  21. Transverse permeability of woven fabrics
  22. Hole expansion simulation of high strength steel sheet
  23. Study of the ultrasonic compaction process of composite laminates - part I: process modeling
  24. Pre-bulging influence on an inverse drawn shape obtained with Hydromechanical Deep Drawing (HDD)
  25. Guiding selection for reduced process development time in RTM
  26. Multiscale simulation of mixing processes using 3D-parallel, fluid-structure interaction techniques
  27. Adaptive remeshing for sheet metal forming in large plastic deformations with damage
  28. 3D laser forming strategies for sheet metal by geometrical information
Search Result: