Paper Search Console

Home Search Page About Contact

Journal Title

Title of Journal: Chem Petrol Eng

Search In Journal Title:

Abbravation: Chemical and Petroleum Engineering

Search In Journal Abbravation:

Publisher

Springer US

Search In Publisher:

DOI

10.1007/s00122-014-2316-9

Search In DOI:

ISSN

1573-8329

Search In ISSN:
Search In Title Of Papers:

Design of the drive of disk extruders for treatmen

Authors: A A Borisov B V Berdyshev
Publish Date: 2013/08/04
Volume: 49, Issue: 3-4, Pages: 238-245
PDF Link

Abstract

The article is devoted to one of the critical problems that arise in the course of designing disk extruders – that of determining the goodness of fit of an estimate of the energy characteristics of the drive power torque etc that will assure reliability operation of the equipment

Keywords:

References

.
Search In Abstract Of Papers:
Other Papers In This Journal:
  1. Selection of a method of detoxification of oil-containing soils
  2. New designs of bimetallic finned tubes for air-cooled heat exchangers
  3. Equipment and working conditions for comprehensive treatment of discharges containing halogen-bearing pollutants
  4. Analysis of a Combined Type of Membrane Device for Purification of Industrial Solutions by Ultrafiltration
  5. Analysis of a Management System for Industrial Safety at Oil Refineries
  6. Mathematical modeling of a wire-coil insert for heat-exchange enhancement in a tube passing a transitional flow
  7. Evaluation of Structure, Phase Composition, and Operating Properties of Coatings Made by Laser Surfacing. Part 2 *
  8. Modelling of Polymer Melting in Screw Extruder Channels
  9. Development and Calculation of a Liquid Cooling System for a Piston Compressor Using Pressure Fluctuations During Gas Discharge
  10. Computer analysis of the effect of structural and regime operating parameters of a vortical ejector on the coefficient of injection
  11. New-generation 620–310 kW three-plunger pulp pumps made by Ulanashskii Mashzavod
  12. Screw extruder mixing and dispersing units
  13. Apparatus with Intracyclic Variation of the Velocity of the Anchor Agitator
  14. Improvement of Dynamic Thermal Diffusion Galvanizing Production Process Efficiency
  15. Study of Turning Polymer Materials Taking Account of Prior Workpiece Treatment with Surface-Active Substances
Search Result: