Paper Search Console

Home Search Page About Contact

Journal Title

Title of Journal: Tribol Lett

Search In Journal Title:

Abbravation: Tribology Letters

Search In Journal Abbravation:

Publisher

Springer US

Search In Publisher:

DOI

10.1016/j.beproc.2012.10.007

Search In DOI:

ISSN

1573-2711

Search In ISSN:
Search In Title Of Papers:

Study on Surface Asperity Flattening in Cold Quasi

Authors: Hejie Li Zhengyi Jiang Dongbin Wei Jianzhong Xu Xiaoming Zhang Dianyao Gong Jiangtao Han
Publish Date: 2015/05/05
Volume: 58, Issue: 3, Pages: 46-
PDF Link

Abstract

In order to study the surface asperity flattening in a quasistatic cold uniaxial planar compression the experimental results of atomic force microscope and electron backscattered diffraction have been employed in a ratedependent crystal plasticity model to analyze this process The simulation results show a good agreement with the experimental results in this quasistatic deformation process lubrication can hinder the surface asperity flattening process even under very low deformation rate However due to the limitation of the model and some parameters the simulation results cannot predict all the properties in detail such as S orientation 123 634 and the maximum stress in sample compressed without lubrication In addition the experimental results show with an increase in gauged reduction the development of Taylor factor and CSL boundaries show certain tendencies Under the same gauged reduction friction can increase the Taylor factor and Σ = 7


Keywords:

References


.
Search In Abstract Of Papers:
Other Papers In This Journal:

  1. A Film Thickness Correction Formula for Double-Newtonian Shear-Thinning in Rolling EHL Circular Contacts
  2. An investigation into friction behaviour of dispersion-strengthened copper under severe railway braking conditions
  3. In Situ NbC Particulate-Reinforced Iron Matrix Composite: Microstructure and Abrasive Wear Characteristics
  4. The Role of Ferric Oxide Nanoparticles in Improving Lubricity and Tribo-Electrochemical Performance During Chemical–Mechanical Polishing
  5. Influence of Post-treatment on the Microstructural and Tribomechanical Properties of Suspension Thermally Sprayed WC–12 wt%Co Nanocomposite Coatings
  6. Lateral Vibration Analysis of Flexible Shafts Supported on Elliptical Journal Bearings
  7. Influence of Friction on Surface Asperity Flattening Process in Cold Uniaxial Planar Compression (CUPC)
  8. Effect of Surface Roughening of Substrate Steel on the Improvement of Delamination Strength and Tribological Behavior of Hydrogenated Amorphous Carbon Coating Under Lubricated Conditions
  9. Transmission Electron Microscopy Analysis of Mo–W–S–Se Film Sliding Contact Obtained by Using Focused Ion Beam Microscope and In Situ Microtribometer
  10. Effect of Chromium on Oxidation in Wear of Surface Nanocrystalline Martensite Steel
  11. Design of a New Tribometer for Tribological and Viscoelasticity Studies of PTFE Valve Seats
  12. Tribochemistry of Bulk Zinc Metaphosphate Glasses
  13. Simulation of Hydrocarbon Oil Contamination at the Head–Disk Interface Using Molecular Dynamics
  14. Impact Abrasive Wear Response of Carbon/Carbon Composites at Elevated Temperatures
  15. Analyzing Periodic Signals in Rotating Pin-on-Disc Tribotest Measurements Using Discrete Fourier Transform Algorithm
  16. Frictional Voltammetry with Copper
  17. Polymer-Brush Lubrication in Oil: Sliding Beyond the Stribeck Curve
  18. Explanation for the mechanical strength of amyloid fibrils
  19. Experimental investigation of frictional and viscoelastic properties of intestine for microendoscope application
  20. The Role of Functional End Groups of Perfluoropolyether (Z-dol and Z-03) Lubricants in Augmenting the Tribology of SU-8 Composites
  21. Dissipation of Vibration in Rough Contact
  22. Movement of Entrapped Oil Under Pure Rolling Conditions
  23. High-Temperature Friction and Wear of Ag/h-BN-Containing Ni-based Composites Against Steel

Search Result: