Paper Search Console

Home Search Page About Contact

Journal Title

Title of Journal: IntJ Automot Technol

Search In Journal Title:

Abbravation: International Journal of Automotive Technology

Search In Journal Abbravation:

Publisher

The Korean Society of Automotive Engineers

Search In Publisher:

DOI

10.1007/bf00701081

Search In DOI:

ISSN

1976-3832

Search In ISSN:
Search In Title Of Papers:

Simulation of HCCI combustion with spatial inhomog

Authors: Y J Lee K Y Huh
Publish Date: 2010/04/01
Volume: 11, Issue: 1, Pages: 19-26
PDF Link

Abstract

There has been recent interest in a new engine type Homogeneous Charge Compression Ignition HCCI to combine the advantages of SI and CI engines In this paper a locally deterministic approach is employed to consider spatial inhomogeneities using the KIVACHEMKIN package Validation is performed for two experimental HCCI engines fueled respectively by hydrogen and nheptane The full mechanism for hydrogen and a skeletal mechanism for nheptane are used for combustion chemistry Differences in the reaction flow paths are shown at ignition and the heat release reaction stages of the two fuels Results show good agreement between measured and calculated pressures for different initial mixture temperatures with estimated residual fractions A parametric study is performed in both engines to consider the influences of the physical parameters wall temperature swirl ratio and global equivalence ratio The ignition time of nheptane is shown to be relatively insensitive to variations in these parametric due to its twostage ignition behavior


Keywords:

References


.
Search In Abstract Of Papers:
Other Papers In This Journal:

  1. Sliding-mode observer for urea-selective catalytic reduction (SCR) mid-catalyst ammonia concentration estimation
  2. Effect of punch angle on energy absorbing characteristics of tube-type crash elements
  3. Combustion development of a Bi-Fuel engine
  4. Fuel economy comparison of conventional drive trains series and parallel hybrid electric step vans
  5. Electrochemical battery model and its parameter estimator for use in a battery management system of plug-in hybrid electric vehicles
  6. Experimental and computational study on recompression reaction of pilot-injected fuel during negative valve overlap in a gasoline-fueled homogeneous charge compression ignition engine
  7. Efficiency improvement for an unthrottled SI engine at part load
  8. Design and evaluation of sideslip angle observer for vehicle stability control
  9. Design and use of an eddy current retarder in an automobile
  10. Common rail injection system iterative learning control based parameter calibration for accurate fuel injection quantity control
  11. Technology analysis and low-cost design of automotive radar for adaptive cruise control system
  12. Robust optimization design method for powertrain mounting systems based on six sigma quality control criteria
  13. Electromagnetic valve train for gasoline engine exhaust system
  14. Impulse-momentum based analysis of vehicle collision accidents using Monte Carlo simulation methods
  15. Detection and isolation of faults in the exhaust path of turbocharged automotive engines
  16. Numerical model for prediction of brake judder due to wear and rust
  17. Thermal anaysis of an electric water pump for internal combustion engine vehicles
  18. Experimental and 3D, embedded modeling for diesel engine SCR deposit
  19. Interior sound field refinement of a passenger car using modified panel acoustic contribution analysis

Search Result: