Paper Search Console

Home Search Page About Contact

Journal Title

Title of Journal: Sci China Technol Sci

Search In Journal Title:

Abbravation: Science China Technological Sciences

Search In Journal Abbravation:

Publisher

Science China Press

Search In Publisher:

DOI

10.1002/chin.198911209

Search In DOI:

ISSN

1869-1900

Search In ISSN:
Search In Title Of Papers:

Simulation and experiment of vortex transport prop

Authors: Lai Jiang WeiWei Xu Tao Hua Mei Yu DeYue An Jian Chen BiaoBing Jin Lin Kang PeiHeng Wu
Publish Date: 2014/12/03
Volume: 58, Issue: 3, Pages: 493-498
PDF Link

Abstract

We firstly described a simulation model to investigate the influence of grain boundary GB on the vortex transport properties in YBCO film It is found that the size of inhomogeneous area caused by GB as well as the average velocity in transverse and longitudinal directions shows an angular dependence when the angle θ between the GB and the sample edge varies We have also studied the impact of magnetic field intensity on dynamic behavior of vortex lattice and found that a lower vortex density makes it difficult for the vortex lattice to transfer from pinning state to flow state As the magnetic field is decreased beyond a critical value sharp jumps and strong fluctuations were observed in the I–V curve Finally we conducted measurements on a thin film YBa2Cu3O7δ with an individual artificial grain boundary to support the simulation process

Keywords:

References

.
Search In Abstract Of Papers:
Other Papers In This Journal:
  1. Reynolds number dependence of flow past a shallow open cavity
  2. Theoretical study of electric energy consumption for self-powered chaos signal generator
  3. The solid lubricating material experiment device for Shenzhou-7 Spaceship
  4. Distortion behavior of hydro turbine blade castings during heat treatment processes under variation of seasonal temperature
  5. Research on the feature extraction of DC space charge behavior of oil-paper insulation
  6. Overall optimization of Rankine cycle system for waste heat recovery of heavy-duty vehicle diesel engines considering the cooling power consumption
  7. Inspection of reinforced concrete interface delamination using ultrasonic guided wave non-destructive test technique
  8. Characteristic analysis of unsteady viscous flow around a cavitating propeller
  9. Fabrication and characterization of amorphous ITO/p-Si heterojunction solar cell
  10. Pulsed electrohydrodynamic printing of conductive silver patterns on demand
  11. Modeling and optimal energy management of a power split hybrid electric vehicle
  12. Research on the natural meshing mechanism and testing analysis of scroll profiles for refrigeration scroll compressor
  13. The hydro-abrasive erosion wear behavior of duplex-treated surfaces of AISI H13 tool steel
  14. Magnetic and microwave absorption properties of Ni 1− x Zn x Fe 2 O 4 nanocrystalline synthesized by sol-gel method
  15. Effect of current polarity on electrical sliding wear behavior of Cu-WS 2 -graphite-WS 2 nanotube composites in air and vacuum conditions
  16. Aeroelastic trim and flight loads analysis of flexible aircraft with large deformations
  17. An experimental and numerical study on the charring rate of timber beams exposed to three-side fire
  18. Spatiotemporal dynamics in a network composed of neurons with different excitabilities and excitatory coupling
  19. GPU-accelerated phase field simulation of directional solidification
  20. Synthesis of polycrystalline γ-AlON powders by novel wet chemical processing
  21. A new solution for topology optimization problems with multiple loads: The guide-weight method
  22. Theoretical analysis of flamelet model for supersonic turbulent combustion
  23. Bounding surface model for ballast with additional attention on the evolution of particle size distribution
  24. Recent researches on disaster prevention and mitigation in civil engineering
  25. Vehicle survival patterns in China
  26. Local porosity distribution of cement paste characterized by X-ray micro-tomography
  27. Local porosity distribution of cement paste characterized by X-ray micro-tomography
  28. Thermal control system of Alpha Magnetic Spectrometer
  29. Dynamics of a deflectable-nose missile
  30. Representation of A15 composition and T C in internal-Sn Nb 3 Sn superconducting strands
  31. Matrix perturbation based approach for sensitivity analysis of eigen-solutions in a microgrid
  32. Geometric effects of fuel regression rate in hybrid rocket motors
  33. Contact stress non-uniformity of wafer surface for multi-zone chemical mechanical polishing process
  34. Stability range of tilted dendritic arrays during directional solidification
  35. Phase separation morphology and mode II interlaminar fracture toughness of bismaleimide laminates toughened by thermoplastics with triphenylphosphine oxide group
  36. Inter-basin water transfer-supply model and risk analysis with consideration of rainfall forecast information
  37. Elastoplastic damage model for concrete based on consistent free energy potential
  38. Pattern scaling effect on the radiative properties of wafer’s surface
  39. Study on the glasswares discovered in the underground palace of the Da Bao En Temple in the North Song Dynasty (AD960-AD1127) in Nanjing, China
  40. Study on the critical diameter of the subway tunnel based on the pressure variation
  41. Dynamic simulation based on Jacobian-free Newton-GMRES methods with adaptive preconditioner for power systems
  42. High resolution temperature measurement technique for measuring marine heat flow
Search Result: