Paper Search Console

Home Search Page About Contact

Journal Title

Title of Journal: Bull Mater Sci

Search In Journal Title:

Abbravation: Bulletin of Materials Science

Search In Journal Abbravation:

Publisher

Springer-Verlag

Search In Publisher:

DOI

10.1007/s00701-005-0629-9

Search In DOI:

ISSN

0973-7669

Search In ISSN:
Search In Title Of Papers:

Effect of high thermal expansion glass infiltratio

Authors: A Balakrishnan B B Panigrahi K P Sanosh MinCheol Chu T N Kim SeongJai Cho
Publish Date: 2009/11/06
Volume: 32, Issue: 4, Pages: 393-
PDF Link

Abstract

This work studies the effect on the mechanical properties of alumina10 wt zirconia 3 mol yttria stabilized composite by infiltrating glass of a higher thermal expansion soda lime glass on the surface at high temperature The glass improved the strength of composite at room temperature as well as at high temperature This could be attributed to the drastic drop in the coefficient of thermal expansion due to the compositional change in the soda lime glass during infiltration There was a significant improvement in the Weibull modulus after glass infiltration Glass infiltrated samples showed better thermal shock resistance The magnitude of strength increment was found to be in the order of the surface residual stress generated by thermoelastic properties mismatch between the composite and the penetrated glass

Keywords:

References

.
Search In Abstract Of Papers:
Other Papers In This Journal:
  1. Synthesis and characterization of Sn-doped CdZnS nanoparticles
  2. XPS study of palladium sensitized nano porous silicon thin film
  3. Layered zinc hydroxide–ibuprofen nanohybrids: synthesis and characterization
  4. Effect of substitution of sand stone dust for quartz and clay in triaxial porcelain composition
  5. Adhesive B-doped DLC films on biomedical alloys used for bone fixation
  6. A facile route to synthesis of AgInS 2 nanostructures
  7. Defect-assisted tuning of electroluminescence from p-GaN/n-ZnO nanorod heterojunction
  8. Structural characterization of electrodeposited boron
  9. Preparation and characterization of Fe-V/TiO 2 -SiO 2 nanocatalyst modified by zinc
  10. Study of effect of chromium on titanium dioxide phase transformation
  11. Magneto-structural properties of Ni–Zn nanoferrites synthesized by the low-temperature auto-combustion method
  12. Influence of mineral phase in mineralization of a biocomposite containing chitosan, demineralized bone matrix and bone ash— in vitro study
  13. Antimicrobial coatings — obtaining and characterization
  14. The enhanced interface effect induced by thermal pressure in Nd 0.7 Sr 0.3 MnO y ceramics
  15. Carbon nanotube-based coatings on titanium
  16. Effects of reduction time on the structural, electrical and thermal properties of synthesized reduced graphene oxide nanosheets
  17. Effects of reduction time on the structural, electrical and thermal properties of synthesized reduced graphene oxide nanosheets
  18. Soft lithography meets self-organization: Some new developments in meso-patterning
  19. Morphological and optical properties of n-type porous silicon: effect of etching current density
  20. A thermodynamic approach towards glass-forming ability of amorphous metallic alloys
  21. Role of iron oxide impurities in electrocatalysis by multiwall carbon nanotubes: An investigation using a novel magnetically modified ITO electrodes
  22. AC impedance and dielectric spectroscopic studies of Mg 2 +  ion conducting PVA–PEG blended polymer electrolytes
  23. Temperature dependence of electromechanical properties of PLZT x /57/43 ceramics
  24. Effect of coordination on bond properties: A first principles study
  25. Nano-tribological characteristics of TiO 2 films on 3-mercaptopropyl trimethoxysilane sulfonated self-assembled monolayer
  26. Discrepancy of room temperature ferromagnetism in Mo-doped In 2 O 3
  27. Role of boron addition on the consolidation and properties of steel composites prepared by SPS
  28. Gel–sol synthesis and aging effect on highly crystalline anatase nanopowder
  29. Comparison of in vivo biocompatibilities between parylene-C and polydimethylsiloxane for implantable microelectronic devices
  30. Cobalt oxide nanoparticle-modified carbon nanotubes as an electrocatalysts for electrocatalytic evolution of oxygen gas
  31. Effect of nickel content on the anodic dissolution and passivation of zinc–nickel alloys in alkaline solutions by potentiodynamic and potentiostatic techniques
  32. Photocatalytic degradation of methylene blue by C 3 N 4 /ZnO: the effect of the melamine/ZnO ratios
  33. Fast response time alcohol gas sensor using nanocrystalline F-doped SnO 2 films derived via sol–gel method
  34. Comparison of galvanic displacement and electroless methods for deposition of gold nanoparticles on synthetic calcite
  35. Biphasic calcium phosphate–casein bone graft fortified with Cassia occidentalis for bone tissue engineering and regeneration
  36. Structural and frequency dependencies of a.c. and dielectric characterizations of epitaxial InSb-based heterojunctions
  37. First-principle calculations of the structural, electronic, thermodynamic and thermal properties of ZnS x Se 1− x ternary alloys
  38. On stability of NiTi wire during thermo-mechanical cycling
  39. Temperature-induced control over phase selection among hydroxides of nickel
  40. Yttrium deposition on mesoporous TiO 2 : textural design and UV decolourization of organic dyes
  41. Influence of polymer additive molecular weight on surface and microstructural characteristics of electrodeposited copper
Search Result: