Paper Search Console

Home Search Page About Contact

Journal Title

Title of Journal: Bull Mater Sci

Search In Journal Title:

Abbravation: Bulletin of Materials Science

Search In Journal Abbravation:

Publisher

Springer India

Search In Publisher:

DOI

10.1016/0307-904x(84)90167-7

Search In DOI:

ISSN

0973-7669

Search In ISSN:
Search In Title Of Papers:

Structural characterization of electrodeposited bo

Authors: ASHISH JAIN C GHOSH T R RAVINDRAN S ANTHONYSAMY R DIVAKAR E MOHANDAS G S GUPTA
Publish Date: 2014/02/28
Volume: 36, Issue: 7, Pages: 1323-1329
PDF Link

Abstract

Structural characterization of electrodeposited boron was carried out by using transmission electron microscopy and Raman spectroscopy Electron diffraction and phase contrast imaging were carried out by using transmission electron microscopy Phase identification was done based on the analysis of electron diffraction patterns and the power spectrum calculated from the lattice images from thin regions of the sample Raman spectroscopic examination was carried out to study the nature of bonding and the allotropic form of boron obtained after electrodeposition The results obtained from transmission electron microscopy showed the presence of nanocrystallites embedded in an amorphous mass of boron Raman microscopic studies showed that amorphous boron could be converted to its crystalline form at high temperatures

Keywords:

References

.
Search In Abstract Of Papers:
Other Papers In This Journal:
  1. Synthesis and characterization of Sn-doped CdZnS nanoparticles
  2. XPS study of palladium sensitized nano porous silicon thin film
  3. Layered zinc hydroxide–ibuprofen nanohybrids: synthesis and characterization
  4. Effect of substitution of sand stone dust for quartz and clay in triaxial porcelain composition
  5. Adhesive B-doped DLC films on biomedical alloys used for bone fixation
  6. A facile route to synthesis of AgInS 2 nanostructures
  7. Defect-assisted tuning of electroluminescence from p-GaN/n-ZnO nanorod heterojunction
  8. Preparation and characterization of Fe-V/TiO 2 -SiO 2 nanocatalyst modified by zinc
  9. Study of effect of chromium on titanium dioxide phase transformation
  10. Magneto-structural properties of Ni–Zn nanoferrites synthesized by the low-temperature auto-combustion method
  11. Influence of mineral phase in mineralization of a biocomposite containing chitosan, demineralized bone matrix and bone ash— in vitro study
  12. Antimicrobial coatings — obtaining and characterization
  13. The enhanced interface effect induced by thermal pressure in Nd 0.7 Sr 0.3 MnO y ceramics
  14. Carbon nanotube-based coatings on titanium
  15. Effects of reduction time on the structural, electrical and thermal properties of synthesized reduced graphene oxide nanosheets
  16. Effects of reduction time on the structural, electrical and thermal properties of synthesized reduced graphene oxide nanosheets
  17. Soft lithography meets self-organization: Some new developments in meso-patterning
  18. Morphological and optical properties of n-type porous silicon: effect of etching current density
  19. A thermodynamic approach towards glass-forming ability of amorphous metallic alloys
  20. Role of iron oxide impurities in electrocatalysis by multiwall carbon nanotubes: An investigation using a novel magnetically modified ITO electrodes
  21. AC impedance and dielectric spectroscopic studies of Mg 2 +  ion conducting PVA–PEG blended polymer electrolytes
  22. Temperature dependence of electromechanical properties of PLZT x /57/43 ceramics
  23. Effect of coordination on bond properties: A first principles study
  24. Nano-tribological characteristics of TiO 2 films on 3-mercaptopropyl trimethoxysilane sulfonated self-assembled monolayer
  25. Discrepancy of room temperature ferromagnetism in Mo-doped In 2 O 3
  26. Role of boron addition on the consolidation and properties of steel composites prepared by SPS
  27. Gel–sol synthesis and aging effect on highly crystalline anatase nanopowder
  28. Comparison of in vivo biocompatibilities between parylene-C and polydimethylsiloxane for implantable microelectronic devices
  29. Cobalt oxide nanoparticle-modified carbon nanotubes as an electrocatalysts for electrocatalytic evolution of oxygen gas
  30. Effect of nickel content on the anodic dissolution and passivation of zinc–nickel alloys in alkaline solutions by potentiodynamic and potentiostatic techniques
  31. Photocatalytic degradation of methylene blue by C 3 N 4 /ZnO: the effect of the melamine/ZnO ratios
  32. Fast response time alcohol gas sensor using nanocrystalline F-doped SnO 2 films derived via sol–gel method
  33. Comparison of galvanic displacement and electroless methods for deposition of gold nanoparticles on synthetic calcite
  34. Biphasic calcium phosphate–casein bone graft fortified with Cassia occidentalis for bone tissue engineering and regeneration
  35. Structural and frequency dependencies of a.c. and dielectric characterizations of epitaxial InSb-based heterojunctions
  36. First-principle calculations of the structural, electronic, thermodynamic and thermal properties of ZnS x Se 1− x ternary alloys
  37. On stability of NiTi wire during thermo-mechanical cycling
  38. Temperature-induced control over phase selection among hydroxides of nickel
  39. Yttrium deposition on mesoporous TiO 2 : textural design and UV decolourization of organic dyes
  40. Effect of high thermal expansion glass infiltration on mechanical properties of alumina-zirconia composite
  41. Influence of polymer additive molecular weight on surface and microstructural characteristics of electrodeposited copper
Search Result: